placement of kitchen cabinet knobs and pulls

'Where they sit along the length of your cabinet doors is up to you but, as a general rule, you'll want handles and knobs that are on low-level cabinets to be in the top third of cabinet doors. It always goes in the middle For pulls and knobs, place the knob. Tom comments: 'As a rule, you'll always want your hardware to be positioned 50mm away from the top and side edges of your cabinet doors. Placement is the simplest decision you will have to make when adding your drawer handle. Kitchen cabinet knobs and pulls can be installed professionally, if you use a handy template and the right tools. But cabinet knob placement is an issue for many, as some people just dont know exactly where to place the knob on the cabinet door. To measure your cabinet handles and hardware, you'll need a ruler, spirit level, power drill and, most importantly, a steady hand. : Cabinet knobs, especially kitchen cabinet knobs, are very important pieces of hardware. 'It's handy to mark the position of your handles on your cabinets using lengths of masking tape that are cut to the same length as your hardware, then taking a step back and evaluating the placements across your whole kitchen.' How are cabinet handles measured? 'First, use a ruler and pencil to mark the ideal placement of your two drill holes on your cabinets, then check that your holes are perfectly straight using a spirit level. 'Cabinet pulls and hardware are often tricky to get straight, especially T-Bars that have two drill holes,' says Tom. In some cases, you may have a mix of slab-style and shaker cabinet. You can also try putting the pull in top rail right in center. And also, this is the most common placement for pulls on shaker cabinet’s drawers. The recessed drawer panel is called inset basically. 'For the more high-tech DIYers, using a laser level is a highly accurate way to project a straight, horizontally levelled line around your whole kitchen, ensuring perfectly straight handles and knobs.' How do I get my cabinet pulls and hardware straight? The first tip is centering pull in inset panel. 'If you don't apply enough pressure into the drill bit, it will edge off center and result in misaligned holes. 'Drilling confidently is imperative,' says Tom. Multiple mounting locations for knobs and pulls. For Mounting pulls of 3 in., 3-1/2 in., 4 in., and 96 mm center to center sizes. Twenty possible locations for consistent knob mounting are available. To ensure your kitchen cabinet handles and knobs are perfectly aligned whether you’re installing kitchen cabinets that are new and adding them, or doing a swap, you're going to need a ruler and spirit level for your preparation work, then a steady hand for drilling. An alignment guide for easy mounting of knobs and pulls on cabinet doors. (Image credit: Alexandria Hall/Plank Hardware)

Placement of kitchen cabinet knobs and pulls